The most reliable discreet route is to borrow a ring she already wears on the ring finger and measure its inside diameter. GIA notes that rings on other fingers differ, and that the left ring finger is often about half a US size smaller than the right for right-handed people, which is about 1.3 mm of circumference.
Discreet methods, from GIA
Borrow a ring worn on the ring finger and measure it on a mandrel or by its inside diameter.
Trace the inside of a plain band with a pencil on paper, then measure the traced width.
Press the ring into a bar of soap and measure the impression.
Ask a friend or family member.
GIA points out that string and paper can be inaccurate because string stretches and paper curls, so treat them as a last resort.
Turn a measured diameter into a size
Measure across the inside of the ring, at the widest point, in millimeters, then compare with the table. Suppose a borrowed ring measures 16.51 mm across: that is US 6. This is an illustration, not a measurement.
US size
Diameter (mm)
Circumference (mm)
UK
Japan
5
15.70
49.3
J½
9
5.5
16.10
50.6
K½
10
6
16.51
51.9
L½
12
6.5
16.92
53.2
M½
13
7
17.32
54.4
N½
14
7.5
17.73
55.7
O½
15
8
18.14
57.0
P½
16
Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size); UK BS 6820 and Japan JCS equivalents rounded to the nearest listed size.
Plan for an error
GIA advises buying larger when unsure, because it is easier to remove metal than to add it. Jewelers Mutual says a plain band can be stretched up to about half a size and that rings cannot be resized if they are titanium, tungsten, stainless steel or ceramic, or if they are full eternity or delicate pavé styles. Check the resizing policy before buying and keep it within about two sizes, past which a band or setting can be strained.
Settings that are hard to resize
GIA names pavé, channel, eternity, twisted and triple bands and thick bands with melee as harder and costlier to resize. If the setting is one of those, getting the size right before purchase matters more, and a free resize or exchange is worth more than a small price gap.
Wide bands and the knuckle
A band wider than 4 mm usually needs half to one size more (David Yurman), and a large knuckle means measuring both knuckle and base and choosing a size between them. See the wide band guide for the millimeter steps.
Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.