Measuring guide

Do printable ring sizers work? Yes, if you check the scale first

By the Ring Size Tools editorial team · Reviewed 2026-11-05 · How we calculate sizes

A printed ring sizer is as accurate as its print scale. One US ring size is only 0.81 mm of inside diameter, so a sizer printed at 97% instead of 100% makes the ring that matches your finger read about two-thirds of a size too big. Measure the printed scale bar with a ruler before you trust any circle.

Why printing changes your size

US sizes step by 0.032 inch (0.81 mm) of inside diameter per whole size, and a quarter size is about 0.2 mm. Printers and PDF viewers often shrink pages to fit the paper or the printable margins. Every circle and every millimetre mark shrinks with them, and nothing on the page looks wrong.

When the printout is too small, the circle that fits your ring, or the strip mark that meets around your finger, carries a larger label than your true size. When it prints too large, the label is smaller. The table shows how far the reading moves for a finger that is truly US 7 (17.32 mm across).

Actual print scaleReading error (US sizes)Reads
94%+1.36larger
95%+1.12larger
96%+0.88larger
97%+0.66larger
98%+0.43larger
99%+0.21larger
101%-0.21smaller
102%-0.42smaller

Calculated with the US scale definition (diameter in inches = 0.458 + 0.032 × size). The error grows slightly for bigger sizes.

The 30-second scale check

  1. Print with scaling set to 100% or Actual size. Turn off "Fit to page" and "Shrink oversized pages".
  2. Find the reference bar on the printout (a good sizer has one, such as a 50 mm or 100 mm line) and measure it with a ruler.
  3. Or lay a bank card on its printed outline. ID-1 cards (credit, debit and most ID cards) are 85.60 × 53.98 mm under ISO/IEC 7810, so the edges should line up exactly.
  4. If a 50 mm bar measures 48.5 mm, your print is at 97%. Fix the setting and print again rather than trying to correct by eye.

Strip or circles: which printed sizer to use

A typical case

Someone prints a sizer from a phone and gets US 7¾, which surprises them because their other rings are a 7. Measuring the printout's 50 mm bar shows 48.0 mm: the page printed at 96%. From the table, that moves the reading by about +0.9 sizes, so their true size is close to US 7. Reprinting at 100% confirms it.

When not to rely on a printed sizer

Already have a measurement in mm? Use the ring size converter or the full ring size chart.

Sources

Error figures calculated by Ring Size Tools.