Measuring

Using string to find your ring size: how accurate is it?

By the Ring Size Tools editorial team · Updated 2026-11-07 · How we calculate sizes

Yes, but treat it as an estimate: wrap string once around the finger, mark the overlap, and measure it in millimeters. 54.4 mm is US 7 and 57.0 mm is US 8, so an error of 1.6 mm already moves you a full size.

String length to ring size

USDiameter (mm)Circumference (mm)UKEUJapan
515.7049.3J½499
616.5151.9L½5212
717.3254.4N½5414
818.1457.0P½5716
918.9559.5R½6019
1019.7662.1T½6221

Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size); UK BS 6820, EU (ISO 8653 inside circumference) and Japan JCS values rounded to the nearest listed size.

Method

  1. Use non-stretch string, dental floss or a paper strip, not yarn.
  2. Wrap it once around the base of the finger, snugly, where the ring will sit.
  3. Mark where the end meets the string with a pen.
  4. Lay it flat and measure with a ruler in millimeters.
  5. Repeat three times and average, then read the table.

How big the error can be

One US size is 2.5 mm of circumference. A ruler is read to about 0.5 mm, string can stretch or slip, and a thick string adds roughly its own diameter times pi to the loop. A 1 mm string wrapped once can add about 3 mm, almost two sizes, if the mark is made on the outside of the loop. Use the inner edge of the string, or a thin paper strip, to avoid this.

Worked example

Suppose three string readings are 54.5, 55.0 and 54.8 mm, average 54.8 mm. The table puts that between US 7 (54.4 mm) and US 7.5 (55.7 mm). Because a ring that is too small is harder to fix than one slightly large (GIA), choose the larger or confirm with a ring you own. This is a hypothetical illustration of the arithmetic.

Check the knuckle too

The ring must pass the knuckle and sit at the base. If your knuckle is much larger than the base, measure both and pick a size that passes the knuckle without spinning freely. GIA recommends measuring at the end of the day when fingers are largest.

Keep a record

Write down the measured millimeters, the unit and the date next to the size you pick, and keep the seller's chart or a screenshot with the order. If the ring arrives and feels wrong, that record shows quickly whether the cause is the chart, your measurement or normal swelling. Fingers change with temperature and time of day (GIA, Jewelers Mutual), so repeat the measurement on a second day before ordering a ring that cannot be resized. Jewelers Mutual notes titanium, tungsten, stainless steel and ceramic rings generally cannot be resized, which makes a careful measurement worth the extra five minutes.

Sources

Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.