Deciding

Between two ring sizes: choosing by ring type

By the Ring Size Tools editorial team · Updated 2026-11-07 · How we calculate sizes

Choose by ring type: wide bands (over 4 mm) need half to one size more, a single thin band up to 2.2 mm takes your true size (David Yurman), and a half size is only about 1.3 mm.

What one step means in millimeters

A whole US size is about 2.5 mm of circumference and a half size about 1.3 mm. That is the scale of every adjustment discussed on this page: a bead that gives roughly half a size (Jewelers Mutual) changes the inside circumference by about 1.3 mm, while a two-size change is about 5.1 mm.

US sizeDiameter (mm)Circumference (mm)
515.7049.3
616.5151.9
717.3254.4
818.1457.0
918.9559.5

Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size).

Decision by ring type

RingLean towardSource
Thin single band, up to 2.2 mmTrue size, or the smaller if it passes the knuckleDavid Yurman
Band over 4 mmHalf to one size largerDavid Yurman, GIA
Stack of bandsHalf size larger, widest at bottomDavid Yurman
Non-resizable ringLarger, then confirm exchangeGIA, Jewelers Mutual
Prominent knuckleBetween knuckle and base sizeDavid Yurman

Why larger is the safe default

GIA advises that metal is easier to remove than add, so a slightly big ring can usually be fixed with a bead or resize while a small one may only stretch about half a size. This does not apply to non-resizable metals, where an exchange policy matters more.

Worked example

Suppose you measure 55.1 mm, halfway between US 7 (54.4 mm) and US 7.5 (55.7 mm). For a 6 mm band the guidance points to US 7.5 or 8; for a 2 mm band, US 7 or 7.5 depending on the knuckle. A hypothetical illustration.

Limits and honest caveats

The sources cited here are general jeweler guidance, not a test of any particular ring. Cost, method and risk depend on the setting, metal and width, so ask a jeweler to inspect the ring before any work. This site does not publish prices because none of the sources give figures we can verify, and the worked examples are hypothetical illustrations of the arithmetic, not reports of real customers.

Sources

Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.