Eternity bands

Eternity band sizing when the ring cannot be resized

By the Ring Size Tools editorial team · Updated 2026-11-07 · How we calculate sizes

Jewelers Mutual lists full eternity rings and delicate pavé among those that cannot be resized, and GIA says eternity and channel settings are harder and costlier to alter. Treat the size as final and measure in millimeters first.

What one step means in millimeters

A whole US size is about 2.5 mm of circumference and a half size about 1.3 mm. That is the scale of every adjustment discussed on this page: a bead that gives roughly half a size (Jewelers Mutual) changes the inside circumference by about 1.3 mm, while a two-size change is about 5.1 mm.

US sizeDiameter (mm)Circumference (mm)
515.7049.3
616.5151.9
717.3254.4
818.1457.0
918.9559.5

Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size).

Why eternity bands are different

Stones run all the way round, so there is no plain metal to cut and solder. GIA notes pavé, channel, eternity, twisted and triple bands and thick bands with small stones are harder or costlier to resize. A half-eternity may still have a plain section at the back, but ask the maker.

Decision table

StyleResize outlookSource
Full eternityGenerally not resizableJewelers Mutual
Delicate pavéGenerally not resizableJewelers Mutual
Channel / eternity / twistedHarder, costlierGIA
Plain section at backAsk the jewelerGeneral

Before you order

  1. Measure the base and the knuckle, twice, at the end of the day.
  2. Compare millimeters with the maker’s chart, not the label.
  3. If between sizes, pick the one that passes the knuckle with slight resistance.
  4. Confirm in writing whether the maker will remake or exchange for size.
  5. If it is a bridal set, GIA says combined widths over 4 to 5 mm need special consideration.

Worked example

Suppose your finger is 53.1 mm and you are choosing between US 6 (51.9 mm) and US 7 (54.4 mm). The half size is 1.3 mm, so US 6.5 is the match and a half-size ring is worth asking for. With a non-resizable ring, the larger of two sizes is the safer choice (GIA: easier to remove metal than add), unless it will spin. A hypothetical illustration.

Limits and honest caveats

The sources cited here are general jeweler guidance, not a test of any particular ring. Cost, method and risk depend on the setting, metal and width, so ask a jeweler to inspect the ring before any work. This site does not publish prices because none of the sources give figures we can verify, and the worked examples are hypothetical illustrations of the arithmetic, not reports of real customers.

Sources

Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.