Slide the ring onto the mandrel until it stops, then read the size at the inside edge; for a wide band GIA says to read from the center of the band. Convert the size to millimeters: US 7 is 54.4 mm.
What one step means in millimeters
A whole US size is about 2.5 mm of circumference and a half size about 1.3 mm. That is the scale of every adjustment discussed on this page: a bead that gives roughly half a size (Jewelers Mutual) changes the inside circumference by about 1.3 mm, while a two-size change is about 5.1 mm.
US size
Diameter (mm)
Circumference (mm)
5
15.70
49.3
6
16.51
51.9
7
17.32
54.4
8
18.14
57.0
9
18.95
59.5
Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size).
Steps
Slide the ring gently down the stick until it stops without forcing.
Read the number at the edge of the ring that is touching the mandrel.
For wide bands, read at the center of the band, as GIA describes.
Convert to millimeters with the table above and note the unit and date.
Remember that the ring may have been worn on another finger, so it may not be your ring-finger size (GIA).
What the reading tells you
A mandrel measures the ring, not your finger. GIA notes middle, index and thumb rings are not the same size as the ring finger, and the left ring finger is about half a size smaller than the right for right-handed people, and the reverse for left-handed. It is a good starting point when you borrow a ring, not a guarantee.
Worked example
Suppose the mandrel reads US 6.5 at the center of a wide band. That is 53.1 mm. Because wide bands usually need more room (David Yurman, GIA), a thin band for the same finger may be a half size smaller, about 51.9 mm for US 6. A hypothetical illustration.
Limits and honest caveats
The sources cited here are general jeweler guidance, not a test of any particular ring. Cost, method and risk depend on the setting, metal and width, so ask a jeweler to inspect the ring before any work. This site does not publish prices because none of the sources give figures we can verify, and the worked examples are hypothetical illustrations of the arithmetic, not reports of real customers.
Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.