Hard metals

Sizing a tungsten or titanium ring when it cannot be resized

By the Ring Size Tools editorial team · Updated 2026-11-07 · How we calculate sizes

Because jewelers generally cannot resize titanium, cobalt, tungsten, stainless steel or ceramic (Jewelers Mutual), the size you order is final. Measure in millimeters, allow for band width, and buy only with a size exchange policy.

What one step means in millimeters

A whole US size is about 2.5 mm of circumference and a half size about 1.3 mm. That is the scale of every adjustment discussed on this page: a bead that gives roughly half a size (Jewelers Mutual) changes the inside circumference by about 1.3 mm, while a two-size change is about 5.1 mm.

US sizeDiameter (mm)Circumference (mm)
515.7049.3
616.5151.9
717.3254.4
818.1457.0
918.9559.5

Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size).

Why the size is final

Jewelers Mutual lists titanium, cobalt, tungsten, stainless steel, ceramic, resin, crystal, enamel and plated rings among those that cannot be resized. Cutting and soldering, the standard method, is not possible, so the only fix for a wrong size is a replacement.

Width changes the right size

Band widthGuidanceSource
Single thin band, up to 2.2 mmTrue sizeDavid Yurman
Over 4 mmAdd half to one sizeDavid Yurman
Wide shankA bit largerGIA

Guidance is from the cited jewelers and is general, not specific to any metal.

One size is 2.5 mm, so a wide band that needs half to one size more adds about 1.3 to 2.5 mm to the inside circumference you should choose.

Order checklist

  1. Measure at the end of the day, twice, not after alcohol or salty food or in hot or cold weather (David Yurman, GIA).
  2. Measure the knuckle and the base and choose between them if the knuckle is bigger.
  3. Convert millimeters to the maker’s own chart, not a generic one.
  4. Choose a seller offering size exchange before you pay.
  5. Keep the measurement record with the order.

Worked example

Suppose you measure 59.5 mm at the base and an 8 mm band is planned. The table gives US 9 for that circumference; the guidance suggests half to one size larger, so US 9.5 to 10 (60.8 to 62.1 mm) would be considered, then confirmed against the seller’s chart. A hypothetical illustration.

Limits and honest caveats

The sources cited here are general jeweler guidance, not a test of any particular ring. Cost, method and risk depend on the setting, metal and width, so ask a jeweler to inspect the ring before any work. This site does not publish prices because none of the sources give figures we can verify, and the worked examples are hypothetical illustrations of the arithmetic, not reports of real customers.

Sources

Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.