Place the ring on the printed circles and pick the circle that touches the inside edge of the band, not the outside. US 7 is a circle of 17.32 mm. A printed circle is only right if the page printed at true scale.
Circle diameters for common sizes
US size
Inside diameter (mm)
Circumference (mm)
4
14.88
46.8
5
15.70
49.3
6
16.51
51.9
7
17.32
54.4
8
18.14
57.0
9
18.95
59.5
10
19.76
62.1
11
20.57
64.6
12
21.39
67.2
Calculated from the US definition (diameter in inches = 0.458 + 0.032 × size).
Neighbouring whole sizes differ by about 2.5 mm of circumference, or about 0.81 mm of diameter. That is under a quarter of a millimeter of diameter between half sizes, which is why print scaling and reading position matter more than the chart itself.
Matching steps
Print the chart and confirm it printed at true scale first (see the scale check page).
Choose a plain band, ideally a ring that fits the finger you want to size. A ring with a stone setting or a domed profile is harder to read.
Stand the ring upright on its edge on the circle, or lay it flat so the inside edge lines up with the printed line.
Look straight down so parallax does not shift the reading. Read the inside edge of the band, not the outside.
If the inside edge sits between two circles, note both sizes and the gap in millimeters rather than rounding.
Write down the size with the date and which finger the ring was worn on.
What the match cannot tell you
It measures the ring, not your finger. GIA notes that the ring finger on the dominant hand is typically about half a size larger and that other fingers differ, so a borrowed ring is only a starting point. Wide bands need more room than thin ones (GIA, Jewelers Mutual), so the diameter you read from a wide ring may be larger than you need for a thin one.
Worked example
Suppose a plain 2 mm band touches the circle labelled 16.92 mm on the inside edge. That corresponds to US 6½, a circumference of 53.1 mm. If you want to buy a 6 mm band on the same finger, the guidance above suggests considering half a size more, about US 7 (54.4 mm). This is a hypothetical illustration of the arithmetic, not a measured case.
When to use something else
If the ring is not a good fit now, the match inherits that. Use the finger-measuring method on the how to measure page, or have a jeweler use a mandrel and sizing set.
Size values on this page are calculated with the Ring Size Tools conversion engine from the published definitions listed on the methodology page. Fit advice is attributed to the sources above.